Message
From
05/08/2003 02:16:29
To
04/08/2003 16:49:37
General information
Forum:
Visual FoxPro
Category:
Reports & Report designer
Miscellaneous
Thread ID:
00816639
Message ID:
00816729
Views:
23
Hi Tracy,
Have you tried these reports to FILE and examined them? How about a hex dump?
Turn the printer off.
Hold the Select key and Form Feed key down at the same time.
Turn the printer on.
Are you using absolute or relative positioning? The only time I have seen 'creep', it was me allowing a line to exceed the page width - one extra space will do it. Or just leaving a extra LF or 2 laying around. Out of curiousity, what emulation and driver have you settled on?
Have you tried these reports to FILE and examined them? How about a hex dump?
Turn the printer off.
Hold the Select key and Form Feed key down at the same time.
Turn the printer on.
Are you using absolute or relative positioning? The only time I have seen 'creep', it was me allowing a line to exceed the page width - one extra space will do it. Or just leaving a extra LF or 2 laying around. Out of curiousity, what emulation and driver have you settled on?