>I recently generated my applicaiton through the FoxPro Setup Wizard. While inside FoxPro 3 I am able to perform all table updates that I want. But in the stand alone edition. I consistently find all my tables are read into memory and made read only cursors.
> Set Multilocks is on
> Cursorsetprop was used (now removed and handled
> by DataEnvironment) as 5 Optimistc Table Buffering
> TableUpdate and Table revert are implemented.
>The forms were created on a network and I performed a local install. (Network install won't work at all)
>Where did I go wrong?
it should probably go to the FAQ - a couple of days ago I answered the same q. for Jon Oswald (sorry if I misspell the name)
the most probable thing is that u have tables/dbc includied in the project and thus generated into the .exe
just exclude them from the project
Arnon
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only