General information
Category:
ActiveX controls in VFP
>>>>Hmmmm. Toughie. Is RThreshold on both controls set to 1 or greater? Are you sure that data is available on both ports? Is there any other code running after the first (last?) port responds? Grasping here...
>>>>
>>>>>Exactly the same. No working
>>>Here is code (INKEY(0.1)) I have added to the first INIT
>>>INKEY(0.1)
>>>This.portOpen = .t.
>>>
>>>helped big time.
>>
>>Really? "first INIT" ... whose INIT?
>The Init of the first added to the form control.
Ok. I don't know what else you might have in there, but I'd remove it all and do any adjusting/setup/opening of those ports until the FORM's INIT. By then, the controls might be ready for use ;-)
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only