General information
Category:
ActiveX controls in VFP
Mark,
It has been a long time, but I seem to remember that comm 3 and 4 share the memory address of comm 1 and 2. You have to do some configuring to get around this but I don't remember what. A quick test would be to try using comm1 and 2 or comm 1 and 4 at the same time as see if that works.
>I still have a problem to get mulptiple mscomm controls to work.
>If I have 3 controls that read data from 3 different comm ports then most of the time even ports are opened OK no data gets read. Works when I use a single control. Any idea?
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only