General information
Category:
Reports & Report designer
Thanks Colin. Please read in the answer to Sergey what I found converting some reports. Fortunately I did not have to change fonts, as I have some reports with Arial 7, which is the minimun I use for reports (I think 6 points is too small for generic use).
>I have many reports that show perfectly in print preview when ReportBehavior is set to 80, but that show ****** in many figures when ReportBehavior is set to 90. I know that the asterisks are because the figure does not fit, but why it behave OK in 80? Moreover, the reports print nicely with out *****.
>
>REPORTBUILDER 80 preview renders using GDI.
>
>REPORTBUILDER 90 preview renders using GDI+. The text algorithms are different in GDI+ and require additional space, as Sergey says.
>
>This was one of the few drawbacks (amongst a lot of good stuff) of using GDI+.
>
>I could resize all of the textboxes, but it would be a lot of work, and besides in some of them I don't have spare space to make them wider. Is there any way to solve this, other than setting ReportBehavior to 80?
>
>Um... you could make the font smaller *ducks*
>
>- Colin
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only