Gaylen,

Thanks SO much! That did it! Thanks for taking the time to post.

Rodd

>Sure have - both for address labels and shipping label.
>
>Make sure you have set up your printer drivers for the type label you are using. Need to set it up in three places. If you are using only an address label - it is set up to run with that as that is the printers defaults. If you are using any other label do the following.
>
>On the general tab - printing preferences - select landscape
>On the Device settings - select the label size you are using
>On the Advanced tab/Printing defaults- make sure the paper size is the same as the label you are using. Should be the same label size as the device settings.
>
>If you are using VFP9 clear out all references to a printer in either you label or report.
>
>Gaylen
>
>
>
>>We have a Dymo thermal label printer. We're trying to use the VFP's native label or report forms to print labels to this printer but having a terrible time doing so. The labels run through the printer longways (that is, the top of the label is the small side approx. 2.275 inches) which means we need to print in landscape mode. Like I said, we just can't get it to work. We keep coming up with the message "Detail band is too large to fit the page".
>>
>>Has anyone succesfully created a VFP label for a Dymo thermal printer?
>>
>>Thanks in advance for your help!