General information
Category:
Coding, syntax & commands
Title:
Not enough memory to complete operation
Hi, All
I try to append records (aprox 1,500,000) to a table on a network drive and receive an error "Not enough memory to complete operation"
This is what I found so far. After I packed a table from 1.5 mln records to 300 records, file size stays the same. I expect file to shrink in size.
If I would start appending records, the error would occur.
I tried to APPEND BLANK record and then to pack file again, file became smaller and no errors. What is going on? Any issues with the network settings? It look like network doesn't release/update the file.
Any ideas?
Thanks in advance.
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only