>>I'm getting an Insufficient Memory error running a FPW2.6a APP (not EXE), and am having little success tracking down the reason for it. I'm running on a Pentium II under Win95 revB with 64MEG RAM installed. The error happens during SHOW GETS or @ ... GET operations. I have set MEMLIMIT 85, 16384, 20480 in my config.fpw, and used SYS(1001) to verify fpw is grabbing 20K. Anyone out there have any suggestions or thoughts I can try before I take the plunge and convert to VFP5.0 (under the suspicion that FPW2.6a and Win95 don't play well together).
>>Thanks for any help,
>>Dave
>Dave,
>
>There is a known problem that is documented in the MSKB about fox 2.x and mchines that run faster than 150MHz causing the insufficient memeory problem. The only solution offered by MS is to slow the cpu down.

Thanks Jim,
I've located the the MSKB article (after being led there by others here) and will shortly be trying a few soulutions suggested/hinted at in an earlier branch of this thread from Dave Frankenbach. I hope to have some results (good or bad) this comming week sometime. I've had a couple other urgent issues that needed attention, and haven't got back to this one yet...
Dave