General information
Category:
Coding, syntax & commands
Hi,
I have a scan..endscan codesnip which behaves strangely. When I use this codesnip alone with the debugger, it works fine (runs through the table). But when I put it to a .prg with other codesnips, it stops after the first record. Interestingly enough if this scan..endscan codesnip runs through a table in which the first record doesnt meet the 'for' condition of scan..endscan command, it works fine as well.
Any idea?
TIA
Tamas Szigeti
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only