General information
Category:
Coding, syntax & commands
Title:
Sys(1104) - how to use?
I am following a thread on a problem with the SUM command in VFP 7. One note by Microsoft is that this behavior will be less likely to occur if the sys(1104) function is used.
I have not previously used this function and I would like to be fully aware of any potential repurcussions of using this function before implementing. One primary question I have: What memory is cleared? Will this lose memory variables, etc.?
Also I have a procedural question: Would it be good programming practice to add this throughout the application, for instance in the Release method of all forms? Refresh method?
Thanks in advance.
David Johnson
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only