Versions des environnements
I changed the following statement in appmain.prg to the following.
SET CLASSLIB TO AppMain, AppForms
SET CLASSLIB TO AppMain, AppForms, cmMsgMan
and then I recompiled. But it did no good. I still get the same error when I run the EXE.????? TIA.
>cmMsgMan is part of my project so I am not sure why it can not be found. The following line is the only line in my appmain.prg that I can find about setting class libraries. Should I add cmMsgMan to this line or should it be added somewhere else?
>
>SET CLASSLIB TO AppMain, AppForms
>
>TIA.
>
>
>
>
>>You need to make sure that the cmMsgMan class library is in the SET CLASSLIB TO stack. cmMessageValue is part of that class library.
>>
>>>I finally wanted to try Cathy Pountney's example on graphing using her report listener example for graphing from her white paper. If I run my program from the project ide it runs fine. If I run it from the command window it runs fine. I have no forms or anything special. The only thing that must be loaded is codemine.prg (I use a select that refers to normalizestring in the original table). But if I run it from my Exe I get this error "Class definition CmMessageValue is not found". I have looked in the Codemine Help but can not find this definition. Any ideas???? TIA.
Précédent
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement