Jay Johengen
Altamahaw-Ossipee, Caroline du Nord, États-Unis
That's an interesting idea too. I've been looking for single piece of something lightweight and strong, but the 2x4s, or even 1x1s would probably work, to give me the strength. I would flip it over from your design which would give the added benefit of putting a small rail around edge to hold the cake and masonite board from sliding off - always a fear. The handles could be notched out of the 2x4 ends before screw the frame to the plywood. I could then add Jim's idea of a neck strap the would go from the two outside/front corners. This might be a good temporary model until I design something out of steel or aluminum. Evan had some great ideas too, but they might take me a bit longer to implement.
>Jay;
>
>How about building a simple frame from 1” X 2” material?
>
>1. Make the frame larger than the largest cake of interest.
>
>2. Use screws to join the frame.
>
>3. Stand the 1” X 2” material on the 1” side and join the four pieces.
>
>4. You can use ½” plywood attached to the top of the frame.
>
>This would give you strength and yet relatively light weight.
>
>Tom
Précédent
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement