General information
Category:
Reports & Report designer
Mark -
I was entering different values for Clip parameters expecting to render different part of a page. But that's not happening
The clip parameters do not dictate the visible area of the rendered page. They dictate the area of the underlying form - the viewport - within which the .OutputPage() method will constrain its drawing.
You then need to size and place the target shape within that viewport area. If you want to display the lower 50% of the page, then 50% of the target shape should be above the top border of the viewport.
Does this make sense?
- Colin
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only