General information
Category:
Reports & Report designer
Hi Giedrius.
>When I'm editing report and changing size of (for example) rectangle using SHIFT and left/up/down/right arrows, I see that rectangle's height or width is changing by 0.03 (sometimes by 0.02).
>Is it possible to set it to 0.01 or somehow set exact height or width of rectangle?
The Report Designer is based on a resolution of 96 dots per inch. So, there are certain size and position values that you cannot use because of this.
Doug
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only