General information
Category:
Reports & Report designer
>I have an application running under VFP 5.0. The User selects a report, and it goes into the Report Preview window. Under Windows 95, it looks fine, the Font (arial 8 point) is readable and the page fills the Preview Window.
>However, under some situations where Windows NT Workstation is installed, the Font is too small to be readable and the previewed page does not fill the entire window.
>On one NT Workstation, the problem occurred if you ran the application from a VFP session (from the command window), but not if you ran
>it as an EXE from a DOS Prompt!
>
>Has anyone seen this kind of discrepancy before?
>
>Thomas Hirschman
Wild shot - what screen resolution and what size fonts are you using on the NT Workstations? I had some forms go very strange when running at high resolution and using large fonts. It was OK on W95. You may have to experiment a bit. I'm running 1152x864, large fonts. (Tried a higher resolution but these eyes are too old <g>.)
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only