>My comment was also ment for Jerry. And I have seen many cases where people have dropped important lines because they did not think they were important. :-)

I don't understand why you don't reply to him directly then.

>
>>I know that, BUT from the code snippet there are no filters. LOCATE would work too.
>>
>>>In general, SEEK In Tablename or SKIP 0 in Tablename are better solutions. In this case the difference may be minimal, but if a SET FILTER is in effect, GO TOP can be extremely slow.
>>>
>>>>Put a GO TOP IN TableName
>>>>
>>>>after every set relation command.
>>>>
>>>>>Thanks! Unfortunately, I tried that and it didn't work, although I tried it again just now. I also tried SCAN...ENDSCAN, and putting additional code before the SEEK line. So far, none of it does the job.
>>>>>
>>>>>Jerry