I am using the MS Comm control to create a program to act as a speakerphone.
I am using AT commands via the MS Comm control to perform this. I have
managed to create a program to dial the number & when the call is answered
the receiver's voice comes out of the computers speakers, but the receiver
cannot hear me talking through the computers microphone.
I have tried using sending the following
Thisform.MSComm1.Output="AT#CLS=8 #VLS=6 #SPK=1,5,1"+chr(13)
#CLS=8 is meant to set the modem to Voice Mode.
#VLS=6 selects speakerphone mode.
#SPK=1,5,1 sets microphone on, Speaker Output to 10dB, Mic gain to 5dB.
I am using a Pace Microlin 56K Voice Internal modem.
Thanks for your help.
David Renton.
mailto:david@css02.globalnet.co.uk
mailto:david@css01.globalnet.co.uk
http://www.users.globalnet.co.uk/~css01
mailto:drenton@141.com
http://www.yi.com/home/RentonDavid