General information
Category:
Forms & Form designer
Bill
I set the the Left and Top properties in the Load event and the Width and
Height in the Init
Arnon
>I am programmatically setting the position and, if applicable, the size of
my forms when they are run. However, when the form(s) shows, there is a
flash as the form is Moved from where the form originally was to its new
position/size. The settings are made in most forms in the form Init, in some
forms, the form Show. The flash appears in either case. I have tried various
combinations of settings for LockScreen, Visible, etc. but the form always
flashes. I know I'm missing something here but I can't put my finger on it.
>
>Thanks,
>Bill
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only