General information
Category:
Forms & Form designer
>I am programmatically setting the position and, if applicable, the size of my forms when they are run. However, when the form(s) shows, there is a flash as the form is Moved from where the form originally was to its new position/size. The settings are made in most forms in the form Init, in some forms, the form Show. The flash appears in either case. I have tried various combinations of settings for LockScreen, Visible, etc. but the form always flashes. I know I'm missing something here but I can't put my finger on it.
>
>Thanks,
>Bill
You could also initiate the form at a position off the visible screen (ie 1000,1000) and then set the position programmatically.
HTH
Rex
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only