>As I understand you are going to INSTALL your application from network. After running Setup.exe the application will be normally installed on WORKSTATION from where you run setup. The directory name pre-defined when you create distribution package (in Setup Wizard) but can be changed during installation. So you have to run this setup once for each workstation.
>Surely, you can install application exe on network drive once for all workstation but MS does not recommend it because of network considerations.
Thank you for your response. After doing the setup once I dont want the user to be able to run the set up again from the main menu on the network. How can I check if it is already installed and give them a msgbox notifying this?
Appreciate any suggestions/tips..
TIA
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only