Right. You have to re-route the printer output to a file, and then force a from feed by issuing Eject. Then the printer buffer will be empty, and you can select the new printer without a form feed.
>I did. However, that requires another SET PRINTER TO command right after the EJECT command to 'close' the printer. Otherwise, the subsequent codes will output the ? to the dump.dmp file.
>
>>Yes, if you have anything at all in the printer buffer set up by VFP, it will issue a form feed when you change to another printer. Did you try my little trick to let a file "eat" the form feed? I used it a lot in "the good old days".
>>
>>>It seems that every time VFP sees a SET PRINTER TO command it forces a form feed. And the formfeed occurs every time the program is ran.
>>>
>>>>I believe VFP tries to be smart, and sends a Form Feed every time you change printer. Anyway, there is an easy way around this.
>>>>Set printer to dump.dmp
>>>>Eject
>>>>Set printer to name (cPrinter)
>>>>Erase dump.dmp
>>>>
>>>>>Hi all,
>>>>>
>>>>>Why does the printer ejects a page when I send this ESC codes to it? We are using the LQ-570e printer. But even when selecting a laser printer, a form feed still occurs.
>>>>>
>>>>>cPrinter = getprinter()
>>>>>if !empty(cPrinter)
>>>>> set printer to name (cPrinter)
>>>>> set printer on
>>>>> * Change the font to COURIER
>>>>> * This line causes the printer to issue a form feed
>>>>> ??? chr(27)+chr(107)+'2'
>>>>> ? "Hello world"
>>>>> set printer off
>>>>> set printer to
>>>>>endif
>>>>>