General information
Category:
COM/DCOM and OLE Automation
>>>>I am setting up Ole Public property of my class but it's not getting saved.
>>>>what would the problem be?
>>>>
>>>>Thanks
>>>Mark,
>>>
>>>I am having the same problem. Did you ever find the solution?
>>>
>>>I have a class that I can build an exe out of and then suddenly it won't hold the OLE Public setting. I can recreate the class, add all methods and properties, build the exe and have the COM object. After I make a few changes to the class, once again it drops the OLE Public setting and I have to rebuild again.
>>>
>>>Matt
>>Try to remove any activex control from your form and see if it still does not hold the flag.
>I will try that Mark.
>
>It is so strange - I can work on the class, rebuild time after time with no problems and then suddenly it will start droppping the OLE Public flag. Since my original post, when I recreated the class from the ground up, it's been fine. The next time it happens I will remove the only ActiveX object - MSCOMM control and see what happens.
>
>Again, Thanks for the reply,
>Matt
MSCOMM - Yep, that's the bad boy I had.
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only