Mike Yearwood
Toronto, Ontario, Canada
General information
Category:
Coding, syntax & commands
Hi Mike,
Thanks for the advice on using the m.lcVar instead of "&". I'm used to using it (&) in clipper programming, but now I know it has different results with VFP9. Just wondering what's the use of "m." in m.lcVar?
Thanks again and I hope I'm not asking too much for advices. All your help are greatly appreaciated.
Sonny
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only