General information
Category:
Reports & Report designer
>>I have used the standard Avery numbering system and built label routines to print a simple mailing list. The routine will print 11 labels (right to the point where an 8 1/2 x 11 page would break) and then skips 11 lables. Any suggestions?
>>
>>Thanks in advance...
>>
>>
>>John Dennis
>
>Just check that "Skip perforations" is not set on in the printers default config.
>Also you may have more luck using a Foxpro for DOS report! That's what I do to print to these old fashioned labels. FPDos reports run fine under FPW and VFP.
>
>Dave
Dave:
Thanks so much for the fpd label tip. That sounds like something worth trying!
jd
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only