General information
Category:
Installation, Setup and Configuration
Title:
No parameter statement found
Hi,
I created an executable and it runs fine from my desktop.
But when I copied it to a cd and and created a autorun.inf and copied this to the same cd and inserted the cd into the cd drive, the exe starts loading but I get an error message 'No parameter statement is found'.
If I ignore this message the executable runs fine. It also runs fine if I open/explore the CD and then run the exe.
Any ideas?
Thanks Zaheed
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only