>>Hi All,
>>
>>We use CodeMine V7.1.02.
>>
>>We had a situation where two workstations where adding data to a local view. The data is entered quickly since the users are scanning barcodes to enter the data. Workstation 1 received a "Uniqueness of index npkey is violated." Then workstation 2 also receives the same error. Workstation 2 cleared the error and then continued scanning without a problem. The primary keys are generated using CodeMines PrimaryKey() function.
>>
>>Looking at the data, workstation 1 started adding adding records with a primary key value of 1, while workstation 2 was adding the correct primary key value. After adding primary keys 1-6 when it got to 7 the uniqueness error occurred, since primary keys 1-6 were not in the table and 7 was. The value for the primary key in appreg01 is correct.
>>So the data in natural order is as follows:
>>PK
>>133201 Workstation 1
>>133202 Workstation 2
>>1 Workstation 1
>>133203 Workstation 2
>>2 Workstation 1
>>3 Workstation 1
>>4 Workstation 1
>>5 Workstation 1
>>6 Workstation 1
>>133204 Workstation 2
>>
>>So why would the primary key start at 1 again when the value for it is correct in appreg01?
>>
>>There have been no changes to this process in over 6 months so I do not understand what could have caused this.
>>
>>Thanks
>>Tom
>
>What is the exact code of PrimaryKey() procedure?
Don't think I can post that here since this is a purchased framework.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only