Which SEEK... the command or the function?
>first I select the table
>Then I do a seek
>it does'nt work
>
>I traced what's happening in the debugger. After the seek I looked to see where was the pointer in the table. Pointer was at the right place. So in debugger it works ok as long as I check for the the content of the table. Out of the debugger the pointer is not positioned at the right place after the seek.
>
>I replaced the seek by a locate and everything works fine.
>
>Why would I have this behavior with the seek?
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only