General information
Category:
Reports & Report designer
Title:
Report or data source issue?
Here's the problem:
I'm trying to build a report from a cursor. In the report designer, I've set the report up to start on a new page when a certain field's data value changes. The first page looks ok, but if I click to go to the 2nd page, only 1 record is shown. If I then click back to the first page, the report designer locks up. I don't know if it is a table issue or a report designer issue. Any suggestions would be appreciated!
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only