General information
Category:
Menus & Menu designer
Title:
Bars Moving Between Pads
Hello Everyone,
I've an s an application that has a .prg that scans through a table and creates a menu using Define Menu, Define Pad, Define Bar as specificied by the data in the record. The menu is then displayed. There's no Skip For code in any of the pads or bars.
Here's the problem. On first use, the menu looks as it should, with the bars under the expected pads. However, after selecting a bar to run and then close a form, report, etc, certain bars are displayed under the wrong pads. The menu hasn't been rebuilt nor has any Skip For code run.
Any thoughts?
Thanks,
Andy
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only