Mike,

Sorry for late reply. In what part did you do the SET PROCEDURE TO... ?

I do it during design time in the Command Window before I drop the grid class.

Dennis


>Dennis,
>
>I do have this procedure set. Like I said, things work fine up until I try to drop this grid class onto a form class.
>
>I've since found out that if I set the grid class's column count to 0 then drop the grid class onto my form class and then at runtime set the column count to what I need, things work fine. I just can't make it work in design/visual mode.
>
>Mike
>
>
>>Mike,
>>
>>Before you drop in onto a form class, first do:
>>
>>

>>SET PROCEDURE TO PrgWhichHasColumnAndHeader.prg
>>

>>
>>Hope it helps,
>>
>>Dennis
>>
>>
>>>I have a grid class that uses the MemberClassLibrary and MemberClass properties. The MemberClassLibrary points to a prg where the column class is defined and it in turn relies on a HeaderClass that is also in the same prg.
>>>
>>>I then drop this grid class on to a container class and set the column count to 2. The two columns appear as expected (using my MemberClass) and their headers are using the HeaderClass (again as expected).
>>>
>>>Now when I try to drop this container onto a form class, I receive the following error:
>>>
>>>"Cannot add this object to a grid"
>>>
>>>My only options are OK and Help. The help says:
>>>
>>>"You have attempted to execute the Grid.AddObject method to add an object other than a column to the grid.
>>>
>>>You are trying to add an object to a column, rather than adding a column to the grid.
>>>
>>>To add an object to a column, use the Grid.Column syntax with the AddObject method."
>>>
>>>Any idea where I went wrong?
>>>
>>>Thanks for all replies,
>>>Mike