General information
Category:
Reports & Report designer
>I am having a problem with the Report Preview window under Windows NT.
>
>Our application goes into a Preview Window before printing, set to a resolution of 100%. In all Windows 95 installations and in most Windows NT Workstations, it shows up fine: the font is readable and the page fills the preview window and the screen. For some of our Beta Sites using Windows NT, the Preview window says it is at 100% but it doesn't look right: the font is too small and illegible and the page doesn't fill the window. It is as if the preview was set to 50% or 75%.
>
>We were directed to the MS Knowledgebase (article Q156788) which suggested that we install the Visual Studio 97 Service Pack on our development machine even though the installation of Visual Foxpro detected no need for the Service Pack. But this has not solved the problem. Has anyone seen this before?
Yep... i see the same problem in 2.6 reports. The higher the resolution on the NT machine, the better you can read it. 640x480 though is illegiable.
BOb
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only