Hi Dave,

That occurred to me too and it must be the answer, but... two of us have gone thru the code several times and not found where that could be happening. I use a standard method to add and remove the containers so you would think that the same thing would happen to other container objects, but it is only one.

The obvious thing at this point is to dismantle that container and rebuild it. I was hoping someone would pipe up with a simple solution.

Thanks for the thoughts,

Ken


>Ken...
>
>I am going to throw in my $.02 worth. Something you can check out very easily. It may seem TOO obvious, but when you add the object on the fly, are you SURE you are adding it to the container? Perhaps, you are adding it to the form and the object persists because its zorder keeps it on top.
>
>Hope that helps.
>...Dave