General information
Category:
Coding, syntax & commands
Hi Neil, thanks for your reply.
Then it is just a matter of sending the Control sequence to that printer.
Exactly how to do this seems to be the problem. To get raw control characyers out, O was using ??? Chr(xxx) etc but this always seemd to go to the directly attached printer , rather then the network shared printer. The Report prints ok to the correct printer but I cant get the control characters out to the correct printer
Regards,
Gerard
>Hi,
>It is usually done by setting up a Generic/Text printer attached to COMx, depending on what port you are using.
>Then it is just a matter of sending the Control sequence to that printer.
>If you are trying to open a cash draw on another workstation just setup a share and attach to it from the other workstation.
>
>>Hi.
>>I am printing to a Till receipt printer with a Cash Drawer attached, from a few networked pc's.
>>(The Till drawer opens by sending Control Cahracters to the Printer)
>>I am using Set Printer to Name (MyName) which is working fine.
>>To open the drawer. I am using ??? plus some print control characters, which work fine on the Local PC, but not on the networked pc's.
>>
>>Does anybody know if ??? goes to the Printer that is Set, or bypasses all this and just goes to a local PC ?, or is there another way of sending the Control Caharacters to the till via the printer
>>
>>Thanks in advance.
>>Gerard
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only