General information
Category:
Reports & Report designer
I have some reports based on queries. I send them to preview before printing but when I click the print icon it replaces the tmpcursor data with the table the select statement was based on, then it prints out the entire table with the report header neatly placed on top of each page. I make sure the cursor is selected yet it prints the table which is not in the selected work area. So, I decided to try the to printer clause in my report form command. Now it paints the report inside the active form with the cursor data, no print. There is no set device commands anywhere in the program yet it paints the active form with the report when I use the clause TO PRINTER PROMPT.
Is this normal?
Eric K.
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only