General information
Category:
The Mere Mortals .NET Framework
Title:
Code Generation Error Adding User Control to Form
Hello all.
I have built a User Control that contains an MM Business Object and a grid to present the BO's data. When I go to place this UC on a form, I get the following error:
"Code generation for property 'State' failed. Error was: 'The value '0' is not a valid value for the enum 'mmBusinessSate'."
Anytime I change anything on the form, the error occurs and recurs each time I save or rebuild until I close and reload the Solution.
When I look in the Form's designer code, it has rendered/created the Business object in the form itself, which shouldn't be the case since the Business object is handled in the User Control.
I suspect this has something to do with Serialization and it may not be specific to MM, but any thoughts/feedback/workarounds for this issue would be much appreciated. Thanks very much...
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only