Hi Marcus,
You are a lot further along than I on this. But I found this in my HP PCL5 Book. Apparently you must issue the command to enable macro for automatic overlay
ESC &f4X
Hope this helps. I'm watching this thread with much interest. Been looking for software that will convert a scanned form to a macro. Ed pointed me to "Inform" which I have not located yet. Possiblly it is Novell Informs.
Ken
>
>Okay, I lied. Thanks for the PCL tip. I appear to be doing exactly what you say, but here's what happens when I print a one page report (no prompt): A page with my overlay prints out, then a page with my data (no image) prints out. Any ideas why this might happen? You've been a tremendous help. Thanks again.
>
>Marcus.
Précédent
Suivant
Répondre
Voir le fil de ce thread
Voir le fil de ce thread à partir de ce message seulement
Voir tous les messages de ce thread
Voir tous les messages de ce thread à partir de ce message seulement