General information
Category:
Reports & Report designer
>>This is a classic problem, with a classic solution: you just can´t do it with variables. You need to calculate, *before* you list anything, the grand total, so it will be available for calculating percentages.
>>
>Sorry about the rookie type questions but if I calculate the percentage values before I run my report, how do I pass the values to my report before it runs.... with the 'with' command like I do in a procedure as in do 'something' with perc1,perc2,perc3 etc. ?
For example, you could create a cursor with the percentages; index it on its primary key, and SET RELATION from your file to it; then, when listing, include the percentage from the cursor.
HTH!
Previous
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only