General information
Category:
Reports & Report designer
Hi Cathy. thanks for replying.
I think I did not explain myself.
(I used Vericla instead of Horizontal !!)
What I want is as follows:
Say I am printing Codes, and I have only one code on a page,
I want separate horizontal lines all down the page as in:
My Code
_________
_________
_________
_________
__________
etc
I.e. I want the page to be filled up with horizontal lines.
At the moment, this only happens as long as I have a Code on
each line. If I dont have a code on each line, I still want
a 'blank' horizontal line
Regards,
Gerard
>Start the line in the page header band and finish the line in the page footer band. When the report prints, it will stretch from top to bottom. All you have to do is have the line at least one pixel into those two bands. You can also do similar things with adding a line to a Group Header and Group Footer band and have the line stretch between the bands.
>
>>Hi.
>>Using VFP 8
>>Have a report wihich prints on an A4 page, and I want to print a vertical line under my detail lines.
>>
>>This works fine, but is there a way of printing a vertical line , all doen the page, if I have say only 2 or 3 detail records on the report
>>
>>(I want the report to behave like a form woith preprinted verticl lines, all the wway down to the Page triler section.
>>
>>Thanks in advance.
>>Gerard
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only