I use the RM designer wich creates the code in VB 6 an just traslate it to VFP after design the chart the way I want.
>Thanks for replying Enmanuel.
>
>I'd figured it out since posting here. My problem is that I didn't set the LableAxis.LabelString property (something that the 'quick start' part of the help does not say!)
>
>Mike
>
>
>>I recently did some tests with it. The following code worked fine for me:
>>
>>
>> With Thisform.RMChartX1
>> .Reset
>> * .RMCBackColor = Default
>> .RMCStyle = RMC_CTRLSTYLEFLAT
>> .RMCWidth = 600
>> .RMCHeight = 450
>> .RMCBgImage = ""
>> .Font = "Tahoma"
>> * '************** Add Region 1 *****************************
>> .AddRegion
>> With .Region(1)
>> .Left = 5
>> .Top = 5
>> .Width = -5
>> .Height = -5
>> .Footer = ""
>> * '************** Add Series 1 to region 1 *******************************
>> .AddGridlessSeries
>> With .GridLessSeries
>> .SeriesStyle = RMC_PIE_3D
>> .Alignment = RMC_FULL
>> * .Explodemode = RMC_EXPLODE_BIGGEST
>> .Lucent = .f.
>> .ValueLabelOn = RMC_VLABEL_TWIN
>> .HatchMode = RMC_HATCHBRUSH_OFF
>> .StartAngle = 0
>> * '****** Set data values ******
>> sTemp = "100*67*38*44"
>> .DataString = sTemp
>> EndWith
>> EndWith
>> nRetVal = .Draw(.t.)
>> EndWith
>>
>>
>>
>>I just used the designer and exported the code to VB6, then made the necessary changes to make it work in VFP9.
>>
>>HTH,
>>
>>Enmanuel
>>
>>>Has anyone tried to use the free charting package RMChart in VFP? Specifically the OCX.
>>>
>>>I've managed to put the control on a form and set a few properties but I can't get the actual data to display correctly. I'm trying to test a simple barchart but could only see one data point out of 3 when the form is displayed.
>>>
>>>Regards,
>>>
>>>Mike