General information
Category:
Forms & Form designer
>>>>I do and I did, I still get the same problem.
>>>>
>>>>Yes there is Thisform.lockscreen = .T. in the code.
>>>
>>>Make sure to put it back to .F. (e.g. if method has a premature return and you forget to re-set it to .f. you may have such strange effects).
>>>
>>>So, did I get it right it's run-time problem and in design time your form is ok? That's a relief.
>>
>>No, its the other way around. The runtime is ok, but I cannot see the form in the form designer
>>What I have is the project (.pjx) file. When I open the form is when I open the form is when I see only the blue bar and not the form.
>>
>>I cannot cut and paste to this screen so I cannot show you what I get.
>
>Did you try to re-start VFP? Do you have a good backup?
Yes I restarted VFP 9 (I rebooted my PC). I do not have a lockscreen command in this form. I thought it was good. It is from yesterday when it worked. It stop working this morning. As far as I can tell the other forms are wroking as expected. Only this form shows on the blue (movable) section when I open the form. I can get to properties of the form.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only