General information
Category:
Reports & Report designer
>>VFP5.0 NT 4 with latest service packs on both.
>>
>>I have a one page report which insists on printing 2 copies, even
>>though there is nothing in TAG and TAG2 and EXPR contains the
>>following
>>
>>DRIVER=winspool
>>OUTPUT=Ne01:
>>ORIENTATION=0
>>PAPERSIZE=9
>>COPIES=1
>>DEFAULTSOURCE=15
>>YRESOLUTION=300
>>TTOPTION=2
>>
>>to add to my confusion, the second copy has mangled header - but
>>prints the rest of it OK
>>I have even tried putting COPIES=0 in EXPR in case it was adding 1 to
>>something.
>>
>>All the rest of the reports behave as expected.
>>TIA
>
>Some printers have in the properties sheet some seneral setup tabs. I would start by looking to see if there is an option for number of copies. You may just need to delete the printer, then re-add it. I don't think the problem lies in VFP.
Thanks Mark - I will try that and let you know.
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only