>Yes I am getting the same height regarless of the data.
>My problem is similar of this guy but moore difficult for the fact I have a chart and reading information.
>
>I used the program to generate data from different tables into a cursor.
>Some of data are needed to calcualate the total amount in the reports.
>Therefore, I created some report variables to calcucate the total amount
>and display them in the group footer, and also set up some conditions
>for those data to show the total amount and others not to show.
>The problem is that I cannot shrink the band size for those data not to show
>the total amounts. I try to use "Remove line if blank" in "Print When" option
>for each textfield, but it seems not to work. The outcoming report shows
>as follows:
>
>xxxxxx xxxxxx xxxxxx xxxxxxxxxx
>xxxxxx xxxxxx xxxxxx xxxxxxxxxx
>total amount: xxxxxx
>xxxxxx xxxxxx xxxxxx xxxxxxxxxx
>xxxxxx xxxxxx xxxxxx xxxxxxxxxx
>total amount: xxxxxx
>xxxxxx xxxxxx
>
>xxxxxx xxxxxx
>
>xxxxxx xxxxxx
>
>
>I hope I can shrink the band size as follows
>
>xxxxxx xxxxxx xxxxxx xxxxxxxxxx
>xxxxxx xxxxxx xxxxxx xxxxxxxxxx
>total amount: xxxxxx
>xxxxxx xxxxxx xxxxxx xxxxxxxxxx
>xxxxxx xxxxxx xxxxxx xxxxxxxxxx
>total amount: xxxxxx
>xxxxxx xxxxxx
>xxxxxx xxxxxx
>xxxxxx xxxxxx

Are you sure that line you want to sqeeze is completely empty? You may have some vertical lines or rectangles to prevent squeezing. If it's the case then try firstly to remove them and see how it works.