>Greetings,
>
>I'm trying to call a VFP UDF from a VFP report inside of SagePro ERP. The first time the UDF is called it runs fine from the report and I get the results I want. The problem I have though is that it is locking the UDF into memory somehow. So if I make a change to the UDF, the only way to see the change is to go all the way out of SagePro, log back in, load the module, go through all the report selections and finally print again. This is a horrible development cycle obviously. Is there something I can call that will release this UDF from memory so I can make a change to it and then just run the report again?
>
>Thanks in advance!
>
>Greg
You may try CLEAR PROGRAM, but unfortunately there is no guarantee.
If it's not broken, fix it until it is.
My Blog