General information
Category:
Coding, syntax & commands
Hi Shafid.
I have done that bit ok.
Is there anything else that needs to be done (on my development machine) so that I can include the control on a form , and in a prg file ??
Regards,
Gerard
>Hi Gerard
>I followed Ken's example and it works. (Thanks again Ken).
>Type in REGSVR32 MSCOMM32.OCX in the dos command line and press enter.
>Then run MSCOMM32.REG from run command.
>
>Hope this helps. Shafid
Previous
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only