General information
Category:
Coding, syntax and commands
Title:
Breakpoints in Classes
I have a C# Winform project that has a Reference to a C# class project. I set breakpoints in the class project and then run the Winform and I cannot make it go into the class and stop at the desired line. It just skips over the entire class code segment no matter where I put breaks.
Also, In FoxPro there's a 'step into' Debug function and all I see in my Winforms project is 'Step Over'. I think this is a separate issue(?)
Thanks,
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only