General information
Category:
Reports & Report designer
Title:
VFP 6 reports in VFP 9- margins too narrow
I notice that some (not all) reports that were created in VFP 6, appear to be too wide when printed using VFP 9. Several characters on the extreme-right side of the page are cut-off.
I don't have VFP 6 running, so I cannot go back and look at the margins in the reports as they were created. These single-column reports all now have a page-width of 8.10" and have Printable Page set as the print area. These are generic portrait reports, nothing fancy.
Is there a conversion process I'm missing?
Also, I notice that it takes a very long time for any VFP 6 report to open for editing in VFP 9. VFP 9 reports open instantly.
Could Vista be the problem (is the moon round?)?
Any help appreciated,
Dick Day
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only