Does sys(2019) exit in FPW26? If so, after starting Foxpro, modi comm sys(2019) and verify you are editing the same config file. You can try putting those two files directly in fpw26 and pointing to them there as well. Usually, it doesn't matter as long as those two files exist where you are pointing to them at in the config.fp



>i verified the paths. foxpro is in c:\fpw26, the genscrn files are in the subfolder genscrnx and i am working in a folder c:\kernel. I have the genscrnx files in all 3 folders and tried with config pointing to each but i always get the error. compiling without the lines does work, although with a smaller exe, i cannot figure out what was cut out.
>~M
>
>>You should be able to use Genscrnx though as well. Did you verify the path to those two files listed in your config.fpw you posted is correct?
>>
>>
>>>thanks tracy, worked perfectly, although my exe is smaller that it was before but seems to work just fine without those two lines. i see you've moved ot our neighbourng isle, hope your taking advantage of the unlimited roads
>>>~M
>>>
>>>
>>>>Is the path to _genscrn and _genmenu correct? Remove those two lines and you should get the default. See if that works first...
>>>>
>>>>
>>>>>hi all,
>>>>>i have the folliwing in my config.fpw but i am suddenly getting the error 'cannot find screen/menu generation program', any ideas? this was working a couple of weeks ago when i last used it but today its not.
>>>>>

>>>>>RESOURCE =OFF
>>>>>CATMAN=OFF
>>>>>MVCOUNT=4096
>>>>>_GENSCRN='C:\fpw26\Genscrnx\Genscrnx.prg'
>>>>>_GENMENU='C:\FPW26\Genscrnx\GENMENUX.PRG'
>>>>>

>>>>>~M