You can also start FoxPro and type ? _GENSCRN in the command prompt to see the name and path to the program. Chances are the location for both vars is identical, but it must match their actual location. Also, try recompiling them by typing at the command prompt, COMPILE C:\fpw26\genscrnx\GENSCRNX.PRG and then COMPILE C:\fpw26\genscrnx\GENMENUX.PRG (substitute for the correct path if you've moved them). Also, are those two prgs included in your project by any chance?


>i verified the paths. foxpro is in c:\fpw26, the genscrn files are in the subfolder genscrnx and i am working in a folder c:\kernel. I have the genscrnx files in all 3 folders and tried with config pointing to each but i always get the error. compiling without the lines does work, although with a smaller exe, i cannot figure out what was cut out.
>~M
>
>>You should be able to use Genscrnx though as well. Did you verify the path to those two files listed in your config.fpw you posted is correct?
>>
>>
>>>thanks tracy, worked perfectly, although my exe is smaller that it was before but seems to work just fine without those two lines. i see you've moved ot our neighbourng isle, hope your taking advantage of the unlimited roads
>>>~M
>>>
>>>
>>>>Is the path to _genscrn and _genmenu correct? Remove those two lines and you should get the default. See if that works first...
>>>>
>>>>
>>>>>hi all,
>>>>>i have the folliwing in my config.fpw but i am suddenly getting the error 'cannot find screen/menu generation program', any ideas? this was working a couple of weeks ago when i last used it but today its not.
>>>>>

>>>>>RESOURCE =OFF
>>>>>CATMAN=OFF
>>>>>MVCOUNT=4096
>>>>>_GENSCRN='C:\fpw26\Genscrnx\Genscrnx.prg'
>>>>>_GENMENU='C:\FPW26\Genscrnx\GENMENUX.PRG'
>>>>>

>>>>>~M