General information
Category:
ActiveX controls in VFP
I am working with a winsock. These two commands actually connect it to the remote IP:
RemoteHost = "someIP"
Connect()
If I check State right after Connect() it is 6: Connecting. But what I want is 7: Connected. If I put SLEEP after Connect it does not help. The State is always 6 regardless how long the SLEEP waits, but if I use INKEY then even delaying for 0.1 helps to get State to 7. Any idea?
Thanks
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only