General information
Category:
Installation, Setup and Configuration
In my main program I use the commad: SET HELP TO HELP.CHM
Then, the help.chm works fine in the server
In a network, if I press F1 the CHM file opens OK, and contents are shown on the left side
However the help pages do not appear.
I can see something as below in each page.
Any help or suggestion will be welcome
Moises
=================================================================
This program cannot display the webpage
Most likely causes:
You are not connected to the Internet.
The website is encountering problems.
There might be a typing error in the address.
What you can try:
Check your Internet connection. Try visiting another website to make sure you are connected.
Retype the address.
Go back to the previous page.
More information
================================================================================
Next
Reply
View the map of this thread
View the map of this thread starting from this message only
View all messages of this thread
View all messages of this thread starting from this message only